This course is video based, the NTMA textbook is required,  If you have any questions please contact: Bill Padnos at: bpadnos@ntma.org or 216-264-2828         Read more

This Course will require your Practical Math Textbooks as well as the hand-outs for the additional Math Problems: 272-14 ( PLEASE NOTE:  The Dimension at the bottom tab on this problem is not shown on the set of problems that were sent to you, it should be 5/8 .  This is located between the arrow at the bottom of the "2.425" dimension, and the end of the radius of the 1/ 7/8 dimension) I highly recommend that you write this down NOW, so that you do not forget.  You will also have problems: 274-19 / 276-26 / 277-28 / 281-36 / 281-37 / 286-49 / 287-52 / 288-53 / 289-55  If you have any questions please contact: Bill Padnos at: bpadnos@ntma.org or 216-264-2828   Read more

There is not a textbook with this course due to the advanced nature of the course content.If you have any questions please contact: Carrie Marsico @ (216) 798-7841 or e-mail Carrie at:  cmarsico@ntma.org Read more

You will need the GDT Textbook as well as the 29th edition of the Machinery's Handbook  (This Edition is the one used to identify the reading page assignments ) Please NOTE !!! All reading assignments in the Machiney's Handbook are just that "READING ASSIGNMENTS" They are there for you learning knowledge, there is not an assignment attached to the reading. If you have any questions please contact: Carrie Marsico @ (216) 264-2856 or e-mail Carrie at:  cmarsico@ntma.org Read more

This course is the 5th in a series, it covers applied mathematics that are required to solve for unknown surfaces found on advanced blueprints.  You should have received a PDF File with the problems on it as follows: Advanced Math Problems # 297-74 / 298 / 299 / 300 / 301 / 304-19 / 309-103 / 309-104 / 310-107 / 311-108 / 314-116 / 318 / 320-127 / 322-134 / 324-140 / 325-142 If you have any questions please contact: Bill Padnos bpadnos@ntma.org   Read more

You must have the NTMA Diemaking Textbook to begin this course If you have any questions please contact Bill Padnos@ bpadnos@ntma.org Read more